Differences between revisions 4 and 5
|
Size: 1211
Comment:
|
Size: 1240
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 6: | Line 6: |
| Email: <<MailTo(OE5JFE AT SPAMFREE oevsv DOT at)>> | |
| Line 7: | Line 8: |
| Email: <<MailTo(OE5JFE AT SPAMFREE oevsv DOT at)>> | |
| Line 9: | Line 9: |
| Line 14: | Line 13: |
| Projekt Ideen: J-Pole Antenne für 2m/70cm |
Projekt Ideen: J-Pole Antenne für 2m/70cm |
| Line 21: | Line 20: |
| ===== Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen ===== | ===== Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen ===== |
| Line 25: | Line 23: |
| ===== .tar.gz entpacken ===== ===== Nötiges installieren ===== |
===== .tar.gz entpacken ===== ===== Nötiges installieren ===== {{{ |
| Line 30: | Line 27: |
| }}} | |
| Line 33: | Line 30: |
| ===== build ===== | ===== build ===== {{{ |
| Line 36: | Line 33: |
| }}} {{{ |
|
| Line 38: | Line 36: |
| }}} {{{ |
|
| Line 40: | Line 39: |
| }}} {{{ |
|
| Line 42: | Line 42: |
===== deb bauen ===== |
}}} ===== deb bauen ===== {{{ |
| Line 46: | Line 46: |
===== starten ===== prusa-slicer |
}}} ===== starten ===== {{{ prusa-slicer }}} |
docviper aka Joe
Email: <OE5JFE AT SPAMFREE oevsv DOT at>
Name: Joe
QRZ: https://www.qrz.com/db/OE5JFE
Projekt Ideen: J-Pole Antenne für 2m/70cm
- 300 Ohm Leitung von DX-Wire
- RG 58 mit BNC oder SMA
- Litze
- Schrumpfschlauch mit Schmelzkleber
Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen
wget https://github.com/prusa3d/PrusaSlicer/archive/version_2.1.0.tar.gz
.tar.gz entpacken
Nötiges installieren
sudo apt install cpanminus cmake libboost-all-dev libtbb2 libtbb-dev libcurl4 libmkl-tbb-thread libcereal-dev libeigen3-dev expat libgtest-dev libcurl4-openssl-dev wx-common libplplotwxwidgets1 libwxgtk3.0-dev
cd PrusaSlicer-version_2.1.0/
build
perl Build.PL
mkdir build
cd build/
cmake .. -DCMAKE_BUILD_TYPE=Release -DSLIC3R_WX_STABLE=1
deb bauen
sudo checkinstall
starten
prusa-slicer