Differences between revisions 4 and 6 (spanning 2 versions)
|
Size: 1211
Comment:
|
Size: 1232
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 6: | Line 6: |
| Email: <<MailTo(OE5JFE AT SPAMFREE oevsv DOT at)>> | |
| Line 7: | Line 8: |
| Email: <<MailTo(OE5JFE AT SPAMFREE oevsv DOT at)>> | |
| Line 9: | Line 9: |
| Line 14: | Line 13: |
| Projekt Ideen: J-Pole Antenne für 2m/70cm |
Projekt Ideen: J-Pole Antenne für 2m/70cm |
| Line 21: | Line 20: |
| ===== Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen ===== | ===== Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen ===== |
| Line 23: | Line 22: |
| {{{ | |
| Line 24: | Line 24: |
| }}} | |
| Line 25: | Line 26: |
| ===== .tar.gz entpacken ===== | ===== .tar.gz entpacken ===== |
| Line 27: | Line 28: |
| ===== Nötiges installieren ===== | |
| Line 29: | Line 29: |
| ===== Nötiges installieren ===== {{{ |
|
| Line 32: | Line 34: |
===== build ===== |
}}} ===== build ===== {{{ |
| Line 42: | Line 44: |
===== deb bauen ===== |
}}} ===== deb bauen ===== {{{ |
| Line 46: | Line 48: |
===== starten ===== prusa-slicer |
}}} ===== starten ===== {{{ prusa-slicer }}} |
docviper aka Joe
Email: <OE5JFE AT SPAMFREE oevsv DOT at>
Name: Joe
QRZ: https://www.qrz.com/db/OE5JFE
Projekt Ideen: J-Pole Antenne für 2m/70cm
- 300 Ohm Leitung von DX-Wire
- RG 58 mit BNC oder SMA
- Litze
- Schrumpfschlauch mit Schmelzkleber
Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen
wget https://github.com/prusa3d/PrusaSlicer/archive/version_2.1.0.tar.gz
.tar.gz entpacken
Nötiges installieren
sudo apt install cpanminus cmake libboost-all-dev libtbb2 libtbb-dev libcurl4 libmkl-tbb-thread libcereal-dev libeigen3-dev expat libgtest-dev libcurl4-openssl-dev wx-common libplplotwxwidgets1 libwxgtk3.0-dev cd PrusaSlicer-version_2.1.0/
build
perl Build.PL mkdir build cd build/ cmake .. -DCMAKE_BUILD_TYPE=Release -DSLIC3R_WX_STABLE=1
deb bauen
sudo checkinstall
starten
prusa-slicer